By LaRue0715
#4900224
I purchase a pack blaster sound card from the gbfans site and have a question regarding it. I am having trouble finding the fire sound. Can anyone tell me what the switch configuration is needed to wire up the firing sound or should i just be able to wire directly into the slots that read "fire" and it should work? Even though the button switch that i use works, could it be the switch?

Thanks
Kevin
User avatar
By Christof
#4900247
Have you looked through the documentation for the card? I understand there's a bit of trickery with using a custom wiring setup and NO/NC setups? Alternately, have you left your dip switches in the neutral, test mode configuration? If the Dip switches are all set to off you won't get anything out of the card except the diagnostic mode stuff, which is no sound, just the power indicator light on the board.

    I have a full sized spirit pack, and I have the gh[…]

    If you need any clarification at all, PM me or […]

    Proton Props UK

    Good decision to lift the ban! By the way: I think[…]

    I'd use some putty. Yeah. I'm sorry, I'm not […]