- December 21st, 2021, 1:23 pm#4964040
Hi everybody!
I have been meaning to start a build thread here for a long time now, and here I am finally getting around to it.
I’ve been working on this pack on an off (ok, mostly off) for the last 8 or so years, and I’m just now getting close to finishing.
I really wanted to try to build something that I hadn’t seen before, which is pretty difficult considering how many amazing packs have been built over the years. I originally only wanted to build parts of the big board because it could be seen behind the cyclotron ports. Well that soon evolved into replicating the entire board.
Then Covid hit, and I suddenly had a lot more time on my hands.
I didn’t start out wanting to build a replica of the interior of the original packs, but I’d try something and it would look good, and I’d try something else and it would end up alright. At least it was something to do.
It’s a bit of a compromised design because I’m fitting the interior of the Super Hero into the body of one of the standard GB1 heroes, but I’m really happy with the end result!
Now I just need to finish the shell and wand.
Anyways, on to the pictures...
I have been meaning to start a build thread here for a long time now, and here I am finally getting around to it.
I’ve been working on this pack on an off (ok, mostly off) for the last 8 or so years, and I’m just now getting close to finishing.
I really wanted to try to build something that I hadn’t seen before, which is pretty difficult considering how many amazing packs have been built over the years. I originally only wanted to build parts of the big board because it could be seen behind the cyclotron ports. Well that soon evolved into replicating the entire board.
Then Covid hit, and I suddenly had a lot more time on my hands.
I didn’t start out wanting to build a replica of the interior of the original packs, but I’d try something and it would look good, and I’d try something else and it would end up alright. At least it was something to do.
It’s a bit of a compromised design because I’m fitting the interior of the Super Hero into the body of one of the standard GB1 heroes, but I’m really happy with the end result!
Now I just need to finish the shell and wand.
Anyways, on to the pictures...