- October 8th, 2011, 12:27 pm#350747
Holy. Crap.
The fact that you went from this:
To this:
Blows my friggin mind.
The fact that you went from this:
To this:
Blows my friggin mind.
IPv6Freely wrote:I noticed a lot of people are now using the acrylic tubing. Where did you get it?Master-McCarr is were I got that, along with some nuts and bolts. http://www.mcmaster.com/
jackdoud wrote:Nice pack!Funny story.
You're pencils are upsidown on your booster frame.
IPv6Freely wrote:Your fake welds are just fine. A lot better than many I've seen. Looking great!I used PCB board stand offs as nut inserts.8-32 thread 1/4 inch thick. ACE hardware should have them, thats were I found them. If not here:
What did you stick in your booster tube? Plugs of some sort to screw the frame in?
mburkit wrote:You should go Satin Black, and not look back.I could have sworn that, Vinny, once upon a time said Semi-gloss. So thats what I grabbed the other day.
IPv6Freely wrote:Your scratchbuilding ability is mindblowing.Before this build, I never build anything from scratch. I have little experience when it comes to building something like this.
IPv6Freely wrote:How'd you manage to make your styrene so clean? I've been using the score and snap method, which achieves less than stellar results along the edges..I cheat.
wm6929 wrote:"You've got the tools, you've got the talent!"IPv6Freely wrote:How'd you manage to make your styrene so clean? I've been using the score and snap method, which achieves less than stellar results along the edges..I cheat.
I use a scroll saw.
You can find them pretty cheap at Pawn shops. I have seen them for about $49.
Did it come out today? Ugh the art is so bad tho[…]