GBFans.com

I am nearly finish my first pack. Can anyone give me any specific tips on mounting the frame of the Alice Pack to my proton pack in addition to using the obvious fixing points..........i don't want to make a complete balls of it at this stage.

Honestly, i just drilled some holes in the alice frame, and the motherboard as well and just attached it with bolts, worked great for mine!

here's a few discussions on it I found.

http://www.gbfans.com/community/viewtop ... ting+alice

http://www.gbfans.com/community/viewtop ... ount+alice

An alternate to drilling would be to use brackets that'd screw into the motherboard, and would hold the frame in place against the motherboard.

Awesome info guys, thanks.

I have also seen the ribbon cable clips used to attach the frame further up on each side. i'll check this out.