- October 14th, 2014, 8:37 pm#4814595
I grabbed a couple hammer belt holders, drilled out the rivets (and by drilled, I mean spun till they ripped through the leather.
used some aluminum and an mdf spacer. They should work with the dixie cup mounting brackets I'll be putting on the bottom of the traps.
Since Halloween is close, I figured I better get things done half-assed rather than not at all
used some aluminum and an mdf spacer. They should work with the dixie cup mounting brackets I'll be putting on the bottom of the traps.
Since Halloween is close, I figured I better get things done half-assed rather than not at all