User avatar
By belldandy4087
#344547
I am busy making my slime blower, and i came to a screeching halt. My problem, I can not get a consistent measurement for the height in regards for the were the green tanks sit on the grey tank from the pictures posted. From the top of the green tank to the top of the grey tank. From the pictures I get any where from 8cm to about 17 cm. Can any send me the measurements on what they used?

Also, can someone post the dimensions for the two metal boxes. Did you build these from scratch or use something like a power supply cover? Thanks.
By Cyland Props
#344657
I used 10 1/2" height between the two tanks and the boxes are 3 5/8" H , 3 1/2" W on the heatsink side and 3" deep on the holes side don't forget the legs that stick down.


I wouldn't follow the plans in the equipment section at all , If anything look at my build, because I believe it's the closest that has been done so far.
User avatar
By belldandy4087
#344892
thanks, i appreciate it.

    Make it that pack, sell it for $599. (While I […]

    Yeah, we've been building this thing for ten[…]

    Someone on FB found it. NARDA ELECTROMAGNETIC RADI[…]

    It appears that some time today someone who […]