View new posts | View your posts shodanmark's Slime Blower build.

shodanmark · **Posted:** March 7th, 2012, 5:48 pm

Over the past year or so, I've been collecting parts for a Slime Blower. Due to real life it's been on hold for around 8 months or so. However, now is the time for me carry on and get this done this year.

Here is where I am at the moment:

Still got a while to go.

I'm also want to document everything in as much detail as I can because the little info out there on Slime Blowers is scattered all over the place and the available plans all differ in measurements etc.

Looking to get started on contruction when I have all the parts and when the weather improves to hopefully have it ready for London Film and Comic Con in July.

FunkPunkTwang · **Posted:** March 7th, 2012, 6:29 pm

good luck man!

Jc3394 · **Posted:** March 15th, 2012, 5:24 pm

shodanmark wrote:

... I'm also want to document everything in as much detail as I can because the little info out there on Slime Blowers is scattered all over the place and the available plans all differ in measurements etc..

that's a good call right there. I'm looking to build one after my proton pack and will be scouring the forums for precious info too!

Good Luck sir!

shodanmark · **Posted:** March 15th, 2012, 5:41 pm

Thanks guys. Small update this weekend...

belldandy4087 · **Posted:** March 22nd, 2012, 2:45 pm

Just a little bit of advice, you may want to consider making your "thrower" out of metal. My thower is always getting bumped just from where it hangs. Around waist high. Just a thought. Good luck! Looking forward to your progress

shodanmark · **Posted:** March 22nd, 2012, 5:34 pm

Thanks. I should have a small update this weekend. I'll be using PVC pipe for the thrower covered with sheet aluminium. I'm trying to keep the cost as low as I can so that means I'll have to compromise on a few things. Ordering the metal soon.

shodanmark · **Posted:** April 1st, 2012, 3:34 pm

Well, an update later than expected, but whatever!

Got the heatsinks. Just need to cut a little off of each of the pump box ones.

PVC almost ready for aluminium covering!

I love this tool!

Template ready for the nozzle.

I'm going to need to buy some clamps for this. I've managed without until now, but it's a neccesity with this build!

That's it for now...

EctoTrk · **Posted:** April 1st, 2012, 5:21 pm

Lookin' great. I'm anxious to see how your nozzle will come out.

mikenelson1982 · **Posted:** April 1st, 2012, 9:17 pm

where did you get the black heatsink?

shodanmark · **Posted:** April 2nd, 2012, 12:27 am

I'm anxious too!

Heatsinks are from eBay. Will post links later today when I'm at a computer.

shodanmark · **Posted:** April 2nd, 2012, 6:18 am

Pump box heatsinks
http://www.ebay.co.uk/itm/160675342949

Black Heatsink (not 100% accurate but the extra fins can be added)
http://www.ebay.co.uk/itm/140337008034

MandoMan · **Posted:** April 2nd, 2012, 5:53 pm

Definitely looking forward to seeing this come together!! And big thanks for posting the heatsink links!

View new posts | View your posts shodanmark's Slime Blower build.

Who is online