By dragonspecpc
#4847011
Didn't post to the forums right away, after making my account, so i don't have progressive pics for these. As i haven't added the details yet, i suppose there is room for progressive pics, anyway. But this is my base model.


Image
By dragonspecpc
#4847016
Finally, after tons of searching. I found a Ecto Goggles Model Sticker. "Ecto Detection Goggles Model No. 22801142EP. Warning Special Light sensative devices. Avoid using in brightly lit environments, as severe eye damage may result." Add the generic Danger pack sticker, and Goggle Diagram sticker. Since i'm using Hobart Flex Brasing goggles, my base is more flexible then most peoples' props. So i may or may not add the right side knob, and Open/Closed Circuit labels. Depends on how well a bolt reacts to the rubber, and if i have any short enough.
Image
midmanc82 liked this
By dragonspecpc
#4851514
Thanks. I'm really happy with them. Everything was under 2 bucks a piece. Got the goggles themselves, for 1.71, before shipping. So around 6 to build them
    The journey from commonplace to Ecto-75.

    Whole car is great but the pack trolly...how?

    Proton Props???

    If anyone here is still pondering ordering from th[…]

    I haven't done the new update to the Spirits Unlea[…]

    I ended up grabbing one of the 84 wands just t[…]