User avatar
By slicerd1
Hey guys I original planned to build fully 3d printed googles that are available at thingiverse below. But after printing the whole thing I realized they wouldn't fit over the glasses. I already had purchased some cheap welding goggles before I bought my 3d printer so I now combined to two for the results below. While not screen accurate I think they look pretty good and are nice a light and cost me very little money.

The lenses fit perfectly on top of this style of goggle which are only about $3 on ebay. I also bought some metal stand offs to make the little adjustment knobs. I spray painted the whole thing green and my friend printed me the labels which I modified to fit the goggles.

I built straps using stretchy webbing $3 from the craft store and leather snaps $9 that I already had from building belt fobs.

These fit easilly over my glasses and the lenses actually still flip up so you can see without taking them off if you want.
User avatar
By doctorevil30564
I've been searching online for different types of ghostbuster goggles and I joined this forum just so I could tell you how great yours turned out. I think I am going to do a similar build. Can you advise which of the parts from the thingverse link you gave you used for your build?

It was an action figure of Tracy the gorilla in a […]

This has been a great thread to follow, I love the[…]

RJ is in the middle of doing a thrower run and res[…]

And now I’ve drilled the shell and tapped th[…]