User avatar
By aceblackbelt
Supporting Member
#376508
A bit of an update. Its been a little while but here it is:

I added the cosmetic plate:
Image

The corner plate and an "aluminum" ion arm face:
Image

And now im just waiting for paint to dry on my spacer:
Image
Image
User avatar
By ProtonCharger
#379414
i wouldnt get too crazy finishing this pack with out sealing it with resin. in the end you'll thank yourself for doing that the minute it starts to sprinkle.
User avatar
By aceblackbelt
Supporting Member
#382372
Did some stuff over the past week.

Finished the GB1 style Ion Arm:
Image

I created a shock mount and attached it to the bumper:
Image
Image

Added the filler and beam line tubes with brass fittings and I also added on the small box at the bottom of the spacer and the injector tube receiving box:
Image
Image
User avatar
By aceblackbelt
Supporting Member
#384928
I don't think a single led would put off enough heat to be a concern. But I am thinking about running a 1" pvc pipe through the inside of the cyclotron added where the lights would be to keep a barrier between the lights and the foam.
Libtechinit's Kenner Remodle x2

Love Kenner pack mods. I will be following this.

GBJedi's First Proton Pack Build

First off, good luck with the build dude. Far too […]

I don't believe anything made by OCC would've fit[…]

Ghostbusters Prop Storage

Here are some pics and steps taken: I bought this[…]