We decided to base our dimensions on fitting a Alice Pack frame but we may go the way of a internal strap rig like the actual RGB packs. So far this has been a collaboration of myself, USFMichele and Silverstreak. We plan on sharing any and all dimensions for this build to make it easier for anyone in the community to build one. We will be posting dimensions and plans once the build is complete.
Here is where we are at now:
The concept sketch from the DIC box set
The additional sketches
Got to work on the main pack body
The back layer is 1/4" MDF with a 3/4" MDF body ring and the top layer is 1/2" MDF
We used dowel sections for alignment and will be making the pack body to split open for maintenance
Started in on some of the detail work and figuring out proportions
And there we are for now. Any suggestions or measurements would be appreciated. We want to keep this as open source as possible.
Universal Studios Extreme Pack Restoration/Mod - http://www.gbfans.com/community/viewtop ... =2&t=34735
RGB MDF Pack Build - http://www.gbfans.com/community/viewtop ... =2&t=30017
ECTO 1ATV Power Wheel Build - http://www.gbfans.com/community/viewtop ... 13&t=29800
GB1 Pack Build With Venting - http://www.gbfans.com/community/viewtop ... =2&t=30551