#4896803
Hi, I'm assuming you're talking about the compression nuts + inserts for the 1/4" OD tubing.

Home Depot doesn't do a good job cataloging the availability of their small parts on the Web site, which is why I didn't post a screen shot from the HD site for that part. I found mine just browsing at the store.

But in a pinch, I noticed Lowe's has this brass union:

https://www.lowes.com/pd/Dial-Brass-Eva ... on/3092867

Just take the ends off the middle part and you're good to go.

Hope that helps!

Bill
#4896930
What a fantastic build Astyanax! I'd be over the moon if that was my build. I'm planning on getting a shell kit from nickatron but I'm now also going to use your thread to help me start a scratch build. I will probably use a combination of MDF and EVA foam as I've done a few EVA props before. Should make the pack light too. Well done again.
#4904397
That's a great Pack!!!
Very good job!!! :-D
#4972341
Paranorman wrote: November 1st, 2018, 11:01 am EXCELLANT JOB!! :blush:

Paranorman
I'm honored, thank you! Wouldn't be possible without you blazing the trail for the rest of us!

Three Halloweens and two parties later, the pack is still going strong. Minor repairs here and there, plus a real V-hook, and I'm still happy with the pack! It has an honored place in my GB nook:

Image
Spenglers liked this

Now that we at SAGB have actually got through our […]

Has anyone successfully transferred the pedal el[…]

I have not heard of this. On the Matty PKE, if the[…]

Hard to tell if it’s an actual black fligh[…]