#4883976
I bought a light and sound kit on Ebay , from a seller named heavyprops, below is the list of what's included.
the seller sais I would need this , I have the 12v battery from GBfans, and I also bought the 40w(8ohm) speaker from Gbfans....but my question is either do I need an amp for this kit to work and if so what kind of amp will I need to support my 40w(8ohm) speaker, since I don't have the 4 ohm speaker that he mentions?? please help with any light or suggestions..?

Battery (12v, this will power both light kits as well as most amplifiers)
Amplifier (A small hobby amplifier like the 'Q-Kits 15w mono amp' are perfect)
Speaker (This depends somewhat on your amplifier, but with the above Q-Kits amp, a 4 ohm car speaker works great)
Small piece of speaker wire (To connect the speaker to the amp, and the amp to the sound kit)


Proton Pack Light Kit
- 15 LED Powercell
- 4 Cyclotron LEDs
- 1 Main Switch

Proton Pack Wand Kit
- 15 LED Bargraph (Amber Orange Colored)
- 8 Various LEDs for the wand body
- 1 Red 'Slo-Blo' LED
- 3 Warm White LEDs for the main gun body
- 1 Warm White LED with pre-installed red push button (For the front Wand Ear)
- 2 Blue and Yellow LEDs for the front barrel
- 1 Super-bright LED for the vent light
- 2 Switches (Vent light and misc use switch)
- 1 black push button (Intensify button)

Proton Pack Sound Kit
Sound 1: Pack startup followed by hum
Sound 2: Pack startup no hum (fades out)
Sound 3: Stream fire
Sound 4: Stream wind down followed by hum
Sound 5: Stream wind down no hum
Sound 6: Pack shut down
Sound 7: Pack vent
Sound 8: Pack 'unvent', startup followed by hum
Sound 9: Pack 'unvent', startup with no hum (fades out)
Sound 10: Ghostbusters Theme

    Someone ID'd them on Facebook first, there w[…]

    Two specific ideas I have are basically holiday sp[…]

    While waiting impatiently for Frozen Empire to rel[…]

    Make it that pack, sell it for $599. (While I […]