- March 19th, 2017, 8:10 pm#4891552
I had to fix the front handle on my neutrona wand, it was a bit wobbly. I was told to use a two part epoxy, in this case JB Weld Clear Weld.
Worked out well enough but there was a little bit of the clear Weld trickling down. It's been dry for about a day.
What's the best way to clean it off the wand? It's a relatively small area.
Worked out well enough but there was a little bit of the clear Weld trickling down. It's been dry for about a day.
What's the best way to clean it off the wand? It's a relatively small area.