- April 26th, 2017, 9:17 am#4892999
Please forgive me, the thread title in the previous post had major typos thanks to my phone autocorrecting. Admins, I apologize.
Recently, I noticed my front handle was a bit loose where it connects into the gun body under the clippard valve. I used a two-part epoxy (JB Weld Clear Weld) to strengthen the hold. It worked fine, but after the epoxy dried, I noticed too late that the front handle was a bit misaligned, as you can see in the picture.
It's driving me crazy and I'm unsure how to fix it. Anyone ever deal with this? The whole wand is made from resin.
Recently, I noticed my front handle was a bit loose where it connects into the gun body under the clippard valve. I used a two-part epoxy (JB Weld Clear Weld) to strengthen the hold. It worked fine, but after the epoxy dried, I noticed too late that the front handle was a bit misaligned, as you can see in the picture.
It's driving me crazy and I'm unsure how to fix it. Anyone ever deal with this? The whole wand is made from resin.