#4893367
I'd appreciate some advice on lining up these two shell halves before I commit.

They will need some filling and sorting out but wanted to know if this looked OK.

Some bits don't match at all.

Image
Image
Image
Image

Thanks for the help :wink:
#4893466
It's best to lay the two halves flat, I then fill the gaps with some hot glue just to hold it enough that I can flip it over and add a few pop rivets where the two halves meet. Then I make a brace out of styrene and hot glue that down the center. The rest I fill with two part putty and then fiberglass the entire back of the shell. It's the fiberglass that is holding it together at the point.

Check my build threads for SC packs.

    I don't remember exactly, But I think I've had pr[…]

    Someone ID'd them on Facebook first, there w[…]

    Two specific ideas I have are basically holiday sp[…]

    While waiting impatiently for Frozen Empire to rel[…]