- June 5th, 2017, 10:00 pm#4894304
I designed this mount for the GBFans pack blaster:
Here is the 3d image of the mount.
This is the top view, you can see the yellow color which is part of the mount. The board in screwed into it with four screws.
This is a side view. The mount is glued into the crank generator, and is made so that it is high enough to go over the "ridge" in the middle. You will see why I mounted it here in a second.
This is the front of the crank generator, where the volume pot sticks out so it can utilize the crank as a volume control. Pardon the dust!
Here are a few other mounts I designed to help keep things organized. One is a mount for the blue brick, and the other centers and mounts the power cell lights. The screws on the blue brick near the bottom are set back to allow for space for the wires and the battery switch.
I am making a few other mounts for the other electronics in the pack. I haven't finished those yet.
Here is the 3d image of the mount.
This is the top view, you can see the yellow color which is part of the mount. The board in screwed into it with four screws.
This is a side view. The mount is glued into the crank generator, and is made so that it is high enough to go over the "ridge" in the middle. You will see why I mounted it here in a second.
This is the front of the crank generator, where the volume pot sticks out so it can utilize the crank as a volume control. Pardon the dust!
Here are a few other mounts I designed to help keep things organized. One is a mount for the blue brick, and the other centers and mounts the power cell lights. The screws on the blue brick near the bottom are set back to allow for space for the wires and the battery switch.
I am making a few other mounts for the other electronics in the pack. I haven't finished those yet.