- August 5th, 2017, 4:07 pm#4896538
Hey guys!
I'm building a 3D printed REBOOT Proton Pack which I'm almost complete, but I need to know something... what gauge of copper wire is used to hold the "rainbow" ribbon cable on the five outer pylons around the core and for the ring on the center of the core in the "sqeezer"?
I don't want to buy something that it will be either too thick or too thin since I don't know gauge sizing.
I'm building a 3D printed REBOOT Proton Pack which I'm almost complete, but I need to know something... what gauge of copper wire is used to hold the "rainbow" ribbon cable on the five outer pylons around the core and for the ring on the center of the core in the "sqeezer"?
I don't want to buy something that it will be either too thick or too thin since I don't know gauge sizing.
- Robert ..........
(Formerly "DarthVader1")
Member and Engineer of the Alabama Ghostbusters. https://www.facebook.com/alabamaghostbusters/
(Formerly "DarthVader1") Member and Engineer of the Alabama Ghostbusters. https://www.facebook.com/alabamaghostbusters/
- By robbritton
- By timeware
- By prodestrian
- By RiverofSlime