- September 2nd, 2017, 7:20 pm#4897716
Did some digging, having absolutely zero luck with this.
Trying to figure out the measurements of the "Ear" pushbutton on the Neutrona Wand.
Does anybody have the measurements of the threaded section diameter + length, and the nut diameter across the flats handy?
I'm doing some modifications to an existing 3D Printed wand's models to support the proper switches, and don't have an actual switch in front of me to measure, as my wand is a Matty.
Trying to figure out the measurements of the "Ear" pushbutton on the Neutrona Wand.
Does anybody have the measurements of the threaded section diameter + length, and the nut diameter across the flats handy?
I'm doing some modifications to an existing 3D Printed wand's models to support the proper switches, and don't have an actual switch in front of me to measure, as my wand is a Matty.
- By mike_waclo
- By edspengler
- By pchrisbosh1
- By The amazinga16