User avatar
By WindDrake
#4897716
Did some digging, having absolutely zero luck with this.

Trying to figure out the measurements of the "Ear" pushbutton on the Neutrona Wand.

Does anybody have the measurements of the threaded section diameter + length, and the nut diameter across the flats handy?

I'm doing some modifications to an existing 3D Printed wand's models to support the proper switches, and don't have an actual switch in front of me to measure, as my wand is a Matty.
    Hasbro Ghostbusters

    While you're 100% correct about the function[…]

    Uniform Tips

    It does rain frequently here in London, but not to[…]

    The yellow parts are raw 3D prints, unsanded and u[…]

    Sorry, I hadn't seen any of these replies. Either […]