- September 22nd, 2017, 2:44 pm#4898600
https://www.flickr.com/photos/155015496 ... res/g3835m
This is my first time using styrene for anything this big. Luckily, there are a lot of sharp angles so it hasn't been too difficult thus far (looks nervously at cyclotron plans). Getting the dimensions right has been surprisingly challenging and I'm half considering scrapping what I have and starting again. A few measurements are off. My crank gen is a few Milimetres too short which doesn't seem like much but my OCD can't see past it. It's a fun build tho.
The basic shell will be styrene but everything else will be bought.
This is my first time using styrene for anything this big. Luckily, there are a lot of sharp angles so it hasn't been too difficult thus far (looks nervously at cyclotron plans). Getting the dimensions right has been surprisingly challenging and I'm half considering scrapping what I have and starting again. A few measurements are off. My crank gen is a few Milimetres too short which doesn't seem like much but my OCD can't see past it. It's a fun build tho.
The basic shell will be styrene but everything else will be bought.
twmedford23, jackdoud liked this
- By MasterObi
- By pda4ever
- By mrmichaelt
- By UncannyGirl