- February 12th, 2018, 7:52 am#4903042
Started the crazy endeavor to begin building 6 RGB proton packs at once with the intent of selling them. Most of your are familiar with the my first run of these years back. I'm calling these the Mark II versions because i'm going to be tweaking the electronics in them, hopefully having more resin or 3D pieces where applicable, and planning on pre-wiring these for a sound kit that the buyer can install after the fact.
Any who.. on with the pics
Started cutting out some of the cosmetic pieces using my Festool Jigsaw and sanding them down on the belt sander:
This happened..lol... The belt was pretty old so was to be expected:
All the clamps! In preparation for the next piece to make.
Now some fun pics of my CNC lending a helping hand
Lots of progress so far
Any who.. on with the pics
Started cutting out some of the cosmetic pieces using my Festool Jigsaw and sanding them down on the belt sander:
This happened..lol... The belt was pretty old so was to be expected:
All the clamps! In preparation for the next piece to make.
Now some fun pics of my CNC lending a helping hand
Lots of progress so far
Ghost_Trappin85, Kingpin liked this