By tb-1599
#4909078
So this wont be just a pack thread this is my complete cosplay build thread..(Just posted here since the majority is going to be my pack)
This is What I have collected so far

Spirit Proton Pack (already stripped down and all stickers removed)
Matty Wand
Chemical Gloves
Elbow Pads
1 regular key fob and dog collars and leashes to make more
Spirit PKE meter with holster
Spirit Trap
Spirit Ecto Goggles
Yellow hose
Hose connector
A.L.I.C.E. Frame
Blue battery,
Box-O-Electronics (Songeface LED kit and Matty Blaster various wires and connectors)
Gun Belt (still needs to be dyed grey)
I also have boots (not pictured) from a previous costume.
On order red lenses (for my cyclotron lights)
Sink faucet screens for the vent holes. ( I can't remember what thread I saw that but I am
" borrowing" the idea.
Picking up some other LED and switches tomorrow.
I am dropping off my jump suit and patches to a local place to get attached tomorrow.
Sat I plan on making my mother board (1/4 MDF)
attaching the Songface Alice pack kit.
Sunday it's bondo and paint.
(will add pictures as I go. But this is going to be a weekend only project).
Comments and Constructive crit always welcome...
Image
Image
By NickFame13
#4909112
tb-1599 wrote: September 21st, 2018, 6:19 pm
NickFame13 wrote:Where did you get the holster for your PKE meter?
eBay. Just did a search for PKE meter holster..
Sweet! Thanks!
By tb-1599
#4909165
Not much done today
Added the S hook to my Matty Thrower
swapped out the V hook
Test fitted on the pack
drilled out and and cleaned up the exhaust where I will have the eventual overheating venting.
Played around with some options for replacing the gray plastic shock spring.
Image
Image
Image
Image
NickFame13 liked this
By tb-1599
#4909195
This was a longggggg friggen day and I feel like I haven't got much done.

dyed my belt. (think it came out ok)
Got my mother board cut out. (not the prettiest but it's not like you will see it)
filled and sanded the speaker holes.
mounted the A frame hardware.
Will hopefully paint tomorrow...
Image
Image
Image
proche3 liked this
By proche3
#4909336
Nice! Any qualms about screwing the v hook into the two piece holder? I was debating filling it in and supergluing my 3d printed v hook pieces for fear of cracking the plastic over time with screws. You just drilled pilot holes and it feels pretty good?
By tb-1599
#4909339
Actually I didn't have to drill any holes at all. The two holes I used in the V hook lined up perfectly with the pre-existing holes. You just needs screws small enough to fit through.

    Hey and welcome

    My Little Pony/Ghostbusters crossover done by my d[…]

    Great work identifying the RS Temperature Control […]

    I read Back in Town #1. Spoilers : Hate to b[…]