By kurisu7885
#4910335
I was curious if anyone had a possible lead on a 3D printed V-hook I would use to attach the Matty collector wand to the Spirit Halloween proton pack.

Preferably files as I have a 3D printer already.
By kurisu7885
#4910348
nastynoah wrote: October 30th, 2018, 8:49 pm Print it a high resolution then coat with an epoxy like XTC3D. The hook cracks pretty easy.
Honestly I only really need the male part of the hook.
By kurisu7885
#4910361
This post may contain an affiliate link that helps support GBFans.com when you make a purchase at no additional cost to you.

JulesHiggs wrote: October 31st, 2018, 12:13 pm I bought this non v-hook option at Home Depot, used for hanging pictures securely, at it works like a charm - if you don't care about accuracy.

https://www.amazon.com/OOK-50044-Interl ... B002SV61OI
I may actually consider that so long as it fits the matty wand.
By tb-1599
#4910362
You just have to be careful with the 3d printed hooks I finally went out last night with my pack and Matty wand and my thrower was knocked off twice last night.. Gonna out some rare earth magnet in the male side of the hook. (To secure it more)

    Correct, it grants several in fact the Melody's […]

    Are they just newspaper clippings or something? […]

    If you check the post below from reddit, one of […]

    got a link? It appears that some time today[…]