User avatar
By EnderWeggen
#4911231
Hi everyone I am looking for help on how I can make a copy of a vary nice 9in Tupperware cake container I want to be able to make more than one proton pack and still use the container as it's hard to find
Image

Image

Any help is greatly appreciated
Last edited by EnderWeggen on December 10th, 2018, 10:43 am, edited 2 times in total.
User avatar
By EnderWeggen
#4911259
I am looking at making a copy of it by using Great Stuff Gap and Crack's Expandable Hard Foam Fill. I will try greasing the inside and filling it with the foam and see if I can get a good copy with it. Also I just released this is the first post I have made on my Build woo hoo.
NEW GB MOVIE SUMMER 2020!

I would hope the Ghostbusters are remembered and a[…]

Looking for a full working Trap

I don't doubt that but it was probably something l[…]

Post-SDCC I want to start a new pack build. As muc[…]

ATC Fan Edit

Has anyone seen the ATC Fan Edit below? I'm watchi[…]