By azuma
#4919449
Hi GB fans,

Sorry for the dumb question. I recently bought Benofkent proton pack kits, and I need some advice on motherboard hole drilling. Asides from the placements of the holes? What is the suggested diameter for the holes? Can anyone give a hand? Thank you so much for your time.

Best regards,
Azuma

Image
Ghostbusters 3 Alive Again

Hey, should this thread be moved to the 2020 for[…]

Speaker Mounting?

Probably many good references in member pack bui[…]

[SPOILERS] NEW GB MOVIE SUMMER 2020!

My third, is that the gas tank cap was in a loca[…]

Hehehehehe, there goes Marvel's involvement in S[…]