User avatar
By abritinthebay
Supporting Member
#4935536
They work great for me tbh. Tap the hole & add a nut if you really must but they’ve held for 12 years...
User avatar
By abritinthebay
Supporting Member
#4935549
I guess it depends on the thickness of your surface. I don't even have nuts tbh, I just tapped the holes.
User avatar
By Ectotainment
#4935560
I replaced my clippard screws on the pack with 1 inch 10-32 socket cap head screws with lock nuts, my shell was also too thick for the clippard screws. The ones I had were silver, but I found a method on YouTube of baking them in wet coffee grounds to make them black. It worked pretty well, I had to repeat the process a few times to get them as black as I wanted.
User avatar
By NotSabbat
#4935561
I havent had a problem with the stock screws on my wand Clippard, but the pack Clippard screws are replaced with socket cap screws (at least on the packs I used for reference) so I cant say how well it will hold on the pack side. My pack and wand are both 3d Printed with PETG if that matters to you.

Venkman ran for mayor in the Return novel. It soun[…]

We should all grow evil mustaches to fit the timel[…]

Pretty much this. These illustrations were conce[…]

Auto World is just the Joyride right? Maybe w/ou[…]