- October 9th, 2018, 2:30 pm#4909763
I give you full permission to call me names, but is the plate that goes on top over the "bargraph lights" in the print files? I went to print and don't see that.
- October 9th, 2018, 2:43 pm#4909765
I'm noticing that no one has changed out the red rods on the side. They look a lot thinner than they should be to me. Or am I wrong?
- October 9th, 2018, 6:13 pm#4909768
The red rods that come on the SH Trap are about 0.4", so yes, about a tenth of an inch smaller than what I've seen on plans.
Personally, it doesn't bother me enough to change them out, but I could see how that might bother some people. Not a difficult fix, really.
Personally, it doesn't bother me enough to change them out, but I could see how that might bother some people. Not a difficult fix, really.
- October 24th, 2018, 6:52 pm#4910230
randomZERO wrote: ↑October 10th, 2018, 5:27 pm Nevermind I figured out what I needed. Thanks again.Im so sorry. I just stopped getting emails and didnt know I had posts here.
Best source for flightsuit in UK
- By alphabeta001I've ordered one of these for a friend to use off […]
Ghostbusters: Spirits Unleashed by Illfonic News Thread
- By ChristofGB News is calling the Pink Camo Tint the last m[…]
Favorite William Atherton Movie.
- By 13th FloorSugarland Express.Very early Spielberg movie,it's […]
Some films doing better outside of the U.S. than others?
- By robbrittonAlso probably different release dates. USA[…]