One more Spirit Trap question. (dimensions needed for inside of trap).

One more Spirit Trap question. (dimensions needed for inside of trap).#4909586

By tb-1599 - October 2nd, 2018, 7:45 pm

- October 2nd, 2018, 7:45 pm#4909586

Does anybody either have the measurements for the inside of the trap or a printable pattern? I want to place a piece of frosted acrylic on the bottom of the trap, just above the LED's to hopefully defuse the light a little bit and to hide the LED's. I would rather not open it up if I don't have to...

Re: One more Spirit Trap question. (dimensions needed for inside of trap).#4909589

By TragicManner - October 2nd, 2018, 8:53 pm

- October 2nd, 2018, 8:53 pm#4909589

Inner dimensions are about 4 inches wide, 6.4 inches long. And in case anyone needs to know the height of the compartment below the doors, it's about 2.5 inches tall.

My Modded Spirit Halloween Trap!
My 3D Printed Proton Pack!

Re: One more Spirit Trap question. (dimensions needed for inside of trap).#4909591

By tb-1599 - October 2nd, 2018, 9:36 pm

- October 2nd, 2018, 9:36 pm#4909591

TragicManner wrote: ↑October 2nd, 2018, 8:53 pm Inner dimensions are about 4 inches wide, 6.4 inches long. And in case anyone needs to know the height of the compartment below the doors, it's about 2.5 inches tall.

But it's not a perfect rectangle. That's what I am trying to figure out.

Re: One more Spirit Trap question. (dimensions needed for inside of trap).#4909635

By TragicManner - October 3rd, 2018, 2:26 pm

- October 3rd, 2018, 2:26 pm#4909635

Ah, you mean because of the battery compartment?

My Modded Spirit Halloween Trap!
My 3D Printed Proton Pack!

Re: One more Spirit Trap question. (dimensions needed for inside of trap).#4909638

By TragicManner - October 3rd, 2018, 5:32 pm

- October 3rd, 2018, 5:32 pm#4909638

So, in case that is what you mean, here are the dimensions (this image NOT to scale):

And here is a pdf that IS to scale, make sure it's printed at 100% if you want to use it for a template:
https://www.dropbox.com/s/f0aqy274n4vx1 ... t.pdf?dl=0

My Modded Spirit Halloween Trap!
My 3D Printed Proton Pack!

Re: One more Spirit Trap question. (dimensions needed for inside of trap).#4909641

By tb-1599 - October 3rd, 2018, 7:06 pm

- October 3rd, 2018, 7:06 pm#4909641

TragicManner wrote: ↑October 3rd, 2018, 5:32 pm So, in case that is what you mean, here are the dimensions (this image NOT to scale):

And here is a pdf that IS to scale, make sure it's printed at 100% if you want to use it for a template:
https://www.dropbox.com/s/f0aqy274n4vx1 ... t.pdf?dl=0

That's exactly what I need.. I will show off what I want to do..