GBFans.com

I'm thinking about 3d printing a trap but I think I want to do a GB2 version to match my pack. Has anyone 3d printed this version? I have seen lots of GB1s floating around.

There's minimal difference between the 2. If looking down on it, The knob on the right is now a silver barrel shaped and the side bars on the left are silver instead of red. So you could just print the trap and then customize it to GB2

That's a good idea. I could do that. Wasn't it also a bit smaller?

I used Countspatula files on Thingiverse. He includes the GB2 specific parts in the files too.

https://www.thingiverse.com/thing:1394492

You are a saint! Thank you!