Page 2 of 2

Finding the Wires

Posted: February 19th, 2013, 9:10 am
by danleroy
I found a seller on ebay that has almost all the wires needed for the GB1 cable. HIs ID is brussellex
Look him up and you will see he has almost all the 16 guage wires you will need. I believe there were a couple that he didn't have the correct guage for but perhaps he does now. Best part is he will sell them by the foot so you don't need to buy 25 feet of each one.

Dan

Re: DIY - Ghostbusters 1 Ribbon Cable

Posted: October 14th, 2013, 11:35 pm
by Ejgunth87
Has anyone tried both methods of the e6000 and heat shrink tape/wrap? Trying to figure out which would be the stronger of the 2

Re: DIY - Ghostbusters 1 Ribbon Cable

Posted: April 5th, 2015, 5:25 pm
by saving82
what is the gauge of a single wire? 1.5 mm? thanks

Re: DIY - Ghostbusters 1 Ribbon Cable

Posted: April 23rd, 2015, 5:44 pm
by Ejgunth87
16ga

Re: DIY - Ghostbusters 1 Ribbon Cable

Posted: April 25th, 2015, 5:57 am
by saving82
I wasn't talking about buyng anything. Thanks the same!!

Re: DIY - Ghostbusters 1 Ribbon Cable

Posted: April 25th, 2015, 6:19 am
by bishopdonmiguel
saving82 wrote:I wasn't talking about buyng anything. Thanks the same!!
He answered your question. 16 gauge.

Re: DIY - Ghostbusters 1 Ribbon Cable

Posted: April 25th, 2015, 10:37 am
by saving82
bishopdonmiguel wrote:
saving82 wrote:I wasn't talking about buyng anything. Thanks the same!!
He answered your question. 16 gauge.
ok, thank you all :roland:

Re: DIY - Ghostbusters 1 Ribbon Cable

Posted: August 16th, 2017, 10:24 am
by Theoderic
bishopdonmiguel wrote:
saving82 wrote:I wasn't talking about buyng anything. Thanks the same!!
He answered your question. 16 gauge.
Sorry in case this might be a pretty stupid thing to ask, but:
is it american wire gauge (AWG) or standard wire gauge (SWG)?

Thanks in advance

Re: DIY - Ghostbusters 1 Ribbon Cable

Posted: August 16th, 2017, 11:05 am
by Ejgunth87
AWG

Re: DIY - Ghostbusters 1 Ribbon Cable

Posted: August 17th, 2017, 3:05 am
by Theoderic
Ejgunth87 wrote:AWG
Ooookay - thank you :)