Vacuum forming question
Posted: July 7th, 2017, 8:32 am
Hey guys,
I'm considering attempting to make my own proton pack and was thinking over the logistics of it. If I were to create a vacuum form mold, would I need to compensate for the thickness of the plastic sheet? For example, if I were to use 1/4" plastic sheet with Stefan's plans, would I need to subtract .25" from all of his measurements so that the form will come out right?
Thanks
I'm considering attempting to make my own proton pack and was thinking over the logistics of it. If I were to create a vacuum form mold, would I need to compensate for the thickness of the plastic sheet? For example, if I were to use 1/4" plastic sheet with Stefan's plans, would I need to subtract .25" from all of his measurements so that the form will come out right?
Thanks