By WShawn
#4883739
The base of the handle looks good for the most part. Are you going to try to add the raised lip around the view screen unit back in?
By Randallace
#4883774
Yea- I considered that a "trim" piece - wanted to get the main "bones " of the shape first - will most likely do that when I do the bottom ribs
By Randallace
#4883775
Ran out of supplies - gonna have to get more stuff before I can continue with the screw hole relocation - bummer -

Can concentrate of the wings /arms until I can get those supplies
By WShawn
#4883962
I'd use a Dremel tool to thin the plastic behind the rectangular holes, then use a small drill to perforate the holes, then an X-Acto knife and small file to square them off. You might also have to thin the walls on the viewer "hood" at some point. Your plastic stock might be a little on the thick side.
By Randallace
#4883965
Yea the plastic is on the thick side - I prefer things over engineered and built to last - LOL

I will try and thin it out to shape it - as you suggested --
I'm pleased with how it's progressing so far
Looking to buy a proton pack

Hi I got 500 US dollars to spend on a proton pack […]

If it's possible, would you be willing to get all[…]

2016 Ecto-1 Reference Thread

Found this CO2 regulator that seems very close oth[…]

Reviews

Hmm, come to think of it I don't think I know anyo[…]