- July 9th, 2010, 6:00 pm#244328
The issue with PCBs for the LEDs this thus: The LED locations and the holes in the leading edge of the wing(s) will never line up perfectly. This means one has to bend the LEDs into place, and hope they protrude the right amount. When bending, then you have to be careful not the break the solder point of the leads of the LED; this is exacerbated because of short lead length.
Stuff not many people think about until they are ready to toss the stuff into the trash...
Stuff not many people think about until they are ready to toss the stuff into the trash...