- March 10th, 2017, 9:50 am#4891094
Neutrino Wand / Trap Holster -
This is just a 3D printed Trap / Wand Holster I made so I can put my Wand / Trap on it during a convention! I'd thought I'd just share it with the community for anyone interested in having a cheap print alternative. It has the bottom part pushed forward slightly so you can easily slide your props on and off!
I'll have a Thingiverse link up soon for those who prefer that . Tested and printed on an Ultimaker 2+
( Low quality and 10% infill is just fine and anything higher is better )
DOWNLOAD link : https://www.dropbox.com/s/n9eql3qntwds2 ... r.obj?dl=0
( Clean up still needed of course, fresh off the bed )
This is just a 3D printed Trap / Wand Holster I made so I can put my Wand / Trap on it during a convention! I'd thought I'd just share it with the community for anyone interested in having a cheap print alternative. It has the bottom part pushed forward slightly so you can easily slide your props on and off!
I'll have a Thingiverse link up soon for those who prefer that . Tested and printed on an Ultimaker 2+
( Low quality and 10% infill is just fine and anything higher is better )
DOWNLOAD link : https://www.dropbox.com/s/n9eql3qntwds2 ... r.obj?dl=0
( Clean up still needed of course, fresh off the bed )
Croker liked this
- By edspengler
- By darthbuster
- By Indy Magnoli
- By kahuna900