Post your suggestions or feedback about the site here.
User avatar
By AndFisher
I did PM AJ, and sent an email to the, but not heard back yet.

I am sad to say I'm a little disappointed with the finish of the aluminum trigger. The ring part seems to have gouges either side where its welded to the trigger. I've got some pics to show what I mean. It may not come out on camera, but it more noticeable in person.


I was wondering what could be done about it? Thanks
User avatar
By AJ Quick
That's a by product of the welding process and it occurs when welding thin aluminum.

All our tips have some amount of burn through like that, so do the screen used packs.

These tips are the most accurate that we have ever offered.

nice find! I've not seen a power brick like that b[…]

3D Printed RGB PKE Project

This is awesome!!!! Following this thread.

Yep, done this a lot when hauling several bins of […]

Well... at least we know there will be more comi[…]