[Ecto-Andy]

Hey everyone,
I've seen a few posts like these before, so apologies in advance for covering old ground.
I just thought it'd be better than just randomly PM'ing people, especially as I'm new.

I'm looking to upgrade/replace the proton packs on my old Kenner figures. I was wondering if anyone had a 3D model they'd be willing to share. I don't expect this to be for free. I have access to a 3D printer at work. I've been looking all over, even tried modelling myself (it was terrible).

Thanks in advance for reading this. Any help would be awesome, even if it's just pointing me in the right direction to other places.

[grogking]

How about this one: http://www.thingiverse.com/thing:95750

[Ecto-Andy]

That is perfect, but the bit I really need help with is the part that connects the packs to the figures bodies. The little bit that pops in.
Does anyone have a measurement on that?

[Danzrboy77]

Definitely time for someone to hi-res 3D scan that connection point.

[Ecto-Andy]

Definitely time for someone to hi-res 3D scan that connection point.

You said it! I'm pretty sure I can get a good 3D model for the pack itself, but that connector, that's the issue.