[below_radar_00]

This post may contain an affiliate link that helps support GBFans.com when you make a purchase at no additional cost to you.

Does anyone know where I can get some stands that will 100% for sure fit my 6 inch Matty figures? I did a search on here and found a bunch of 5-6 year old threads and all the stands mentioned have dead links now. I did find the GBFans 3d printed stands but they are almost $5 a pop. I was hoping for $1 a stand since I have a bunch of figures I want to display. I'd probably want to buy about 20.

I did manage to find these for the 12 inch figures: http://www.amazon.com/Kaiser-Doll-Stand ... aiser+2175

And while we're on the subject of figure stands, does anyone have a recommendation for the Matty Real Ghostbusters Retro-Action line?

I've had my figures on a built in shelf for years but I'm moving in a few weeks and I bought glass display cases from a cell phone store and I'm going to put all my figures in those. I've tested this out and found that they don't stand near as well since they are on a glass surface and the case gets bumped into sometimes.

[EctoVR6]

Look for a guy named Tom Servo, or AJ quick had a set he printed.

[B-Rad]

I don't think they are sold in the Shop here anymore but I found the same thing on shapeways http://www.shapeways.com/product/NKUVZG ... Id=9549952

[below_radar_00]

Thanks guys. I found those during my original hunt but I didn't want to pay $4.85 a piece because I want 20 of them. I think I'm going to just use blu-tac. I have the figures on display now and so far only two of them have fallen over. A good bump to the case though and more would probably fall over so at some point I have to get in there and redo everything.