[armysgt1]

I know it says to use an 8 ohm speaker with the amplified sound board I ordered but I was wondering if I could use a 4 ohm speaker by itself or do I absolutely need to use an 8 ohm or have 2 4 ohm speakers? I tried searching but it seems like everyone uses 2 4ohms. Thank you very much guys and sorry if it's a dumb question.

[Venkman's Swagger]

I have 1 4ohm speaker in my pack and it works perfectly fine. I have a video in my GB2 build which should be in my signature if you want to check out how it sounds

[armysgt1]

Thanks a lot! Theres not many options anywhere for 8 ohm speakers that I see and there's a nice pioneer 4 ohm 6x9 I'm interested in.

[bishopdonmiguel]

You'll be fine with a single 4 ohm. If you wanted to install (2) 4-ohm speakers, you should wire in series for 8-ohms (not in parallel for 2-ohms).

[Venkman's Swagger]

Thanks a lot! Theres not many options anywhere for 8 ohm speakers that I see and there's a nice pioneer 4 ohm 6x9 I'm interested in.

You're welcome [emoji1]

Go for it!! Bish has some valuable info there too

[ozzman39]

so will It effect the board at all? or is the 8 ohms just recommended?