- August 21st, 2016, 7:06 am#4877937
I had a few on the ion arm tower that needed removing, but overall it went on okay. I dreaded the drips too. It did a nice job of blending some corners, mind you. Brushing it until it becomes tacky helped.
LandoSystem wrote:Very nice work.Thanks!
I'm currently printing and assembling an 80% scale pack myself.
That XTC3D stuff is pretty handy if you can keep the runs and ripples in check.
I had a few on the ion arm tower that needed removing, but overall it went on okay. I dreaded the drips too. It did a nice job of blending some corners, mind you. Brushing it until it becomes tacky helped.