- August 26th, 2016, 3:48 am#4878647
I'm trying to get quotes for motherboard to be made up in the UK.
One company has quoted me Aluminium 1050, is this going to be too soft?
One company has quoted me Aluminium 1050, is this going to be too soft?
- August 26th, 2016, 1:40 pm#4878689
That should be ok it makes it more workable and will resist the bends better what were you quoted if you dont mind me asking
Mobo cutting files on pdf and dxf available (not free) message for details
- August 27th, 2016, 1:46 pm#4878770
Thats not bad was that including bending it too
Mobo cutting files on pdf and dxf available (not free) message for details
- August 30th, 2016, 1:55 pm#4879031
I'm in the UK and would be interested if you're getting more than one made?
- August 30th, 2016, 3:34 pm#4879048
Mobo cutting files on pdf and dxf available (not free) message for details
- April 16th, 2017, 2:11 pm#4892673
Hey, just noticed this thread. Did you get the board made in the U.K.? Would be interested to see how it turned out as I'm keen to have one made 
Find us @welshghostbust on Twitter, Facebook and Instagram!
Bringing Welsh Ghostbusters together!
http://www.facebook.com/welshghostbust
Bringing Welsh Ghostbusters together!
http://www.facebook.com/welshghostbust
- April 26th, 2017, 12:27 am#4892992
Is the reboot motherboards all the same, so you don't have the issue that can happen with "classic" shells and motherboards not matching up?
Official Mack's Factory Build Thread
- By GhostFaceXFor the legacy shell, what aspects are damage that[…]
- By KingpinRemote Trap Vehicle replica build
- By tobycjAt the moment my interest would be what sorts fo[…]
- By timeware