- December 26th, 2016, 2:42 am#4887857
After following countspatulas 3d files, and making the metal sides myself from 0.8mm thick aluminium, this is where I'm at.
The pedal needs a bit of paint work still, but it is winter and cold outside, and I ran out of black paint just before Christmas =p
Instead of running a wire through the hose and modifying the connectors, I have simply added a small remote control, located in the right box, that is triggered when I press the pedal. Inside the trap will be the receiver and other electronics, just wanting for smaller sprockets..
This will be fully automated as well =)
https://vimeo.com/197080995
The pedal needs a bit of paint work still, but it is winter and cold outside, and I ran out of black paint just before Christmas =p
Instead of running a wire through the hose and modifying the connectors, I have simply added a small remote control, located in the right box, that is triggered when I press the pedal. Inside the trap will be the receiver and other electronics, just wanting for smaller sprockets..
This will be fully automated as well =)
https://vimeo.com/197080995
GBDRE760 liked this