- June 25th, 2017, 3:08 pm#4895013
So I've been hard at work building my pack. Got a shell from etsy, clean up went great fiberglass on the inside drilled and tapped, mounted things and glued/bolted some stuff down. Next step is mounting it to the motherboard. But for the life of me I can't get the sync generator to sit flush. I've checked the level over and over, sanded and dremel-ed away as much as a can. It's entirely possible my shell warped when glassing is there a method for warping it back or should I stick with sanding it slowly back to level. When mounting will the motherboard bend to accommodate? Thanks in advance. I'm using Knowone Designs awesome shell by the way.
Knowone251 liked this