By Sailerm
#4902997
Image
Dummy mock up of the Lights. First off the power meter lights are bigger than the window for them but it's ok. The only real draw back is the power leads for the system comes off the top so I'll have to solder leads to put them where I want
Marcus B liked this
By livewire008
#4903086
Very nice work, man.

Still holding my breath for my kit... ordered October 2016, so hopefully I'll get an email any day now. In the meantime, I'm planning where I want things to go. Just got an Alice frame (not the Anovos one; got tired of waiting for them and ordered from the shop here) getting a real feel for the frame dimensions will inform where I decide to put my motherboard holes for the electronics.
By Marcus B
#4903124
Has anyone seen the alice frame? Might be worth just grabbing one from a surplus store and not waiting. Anovos should be able to churn those out quickly I'd think seeing as companies still make them..
By Xavierallen
#4903385
livewire008 wrote:Very nice work, man.

Still holding my breath for my kit... ordered October 2016, so hopefully I'll get an email any day now. In the meantime, I'm planning where I want things to go. Just got an Alice frame (not the Anovos one; got tired of waiting for them and ordered from the shop here) getting a real feel for the frame dimensions will inform where I decide to put my motherboard holes for the electronics.


I ordered mine March of 2017...still no word on shipment date...meh
By Sailerm
#4903399
Image

The original top bolt was too low causing a lot of flex on the plastic motherboard so I
Added a second bolt with spacer up higher (where it should have been originally). The additional bolt makes the pack much more rigid
By Sailerm
#4903400
Image

Here you can see I have 2 center bolts as well as the two lower bolts.

3/8" x 1/2 stainless lag bolts with wide washers on both inside and outside the mother board with stainless spacers

I couldn't work on my Pack until April 2014, becau[…]

This is from ShadowDion's awesome Ghostbusters Ope[…]

Thanks thats great! How did you keep the metal […]

Haven't heard about anyone with the problem yet. […]