Have a guide or tutorial? Post it up!
By lapena77
#4909006
Im trying to fine measurements To drill holes so I can mount my pack mother board
User avatar
By jreverhart
#4909054
IF your using the GBFans MoBo the holes are predrilled so you can just center it on top of your frame mark the holes with a marker and drill from there.
lapena77 liked this
User avatar
By jreverhart
#4909175
estimates:

top bolt: centered 8.5in from top of Mobo

Bottom bolts: 2.5 in from the sides 4in from the bottom 6.5 in apart

Again these are approximate measurements

Hello, Nick, and welcome!

3D print of a "lightly" modded Ender3, a[…]

Punished Props Proton Pack

I’m willing to help if you want. What&rsqu[…]

Though as a note on the colour, despite contradict[…]