elsoldao7 wrote: ↑September 7th, 2018, 9:14 am Can you post a like to the tutorial?
Darn it! Now I want some extras [emoji35]!
I went back and found the facebok thread from June.
Here ya go-
Tihs is what you will need to do all 4-
4 Slime Blower Winston or Ray
1 Original Movie Winston
1 Original Movie Ray
1 Original Movie Peter
1 Original Movie Egon
1 "We're Back" GB2 Egon
1 "We're Back" GB2 Ray or Winston (depending on which Slime Blower figures you use as you will have one of these 2 already, or even both if you use different ones... point being you need 1 GB2 Ray head and 1 GB2 Winston head).
1 "We're Back" GB2 Peter
Begin by removing the right arm from all 4 Slime Blower figures. Do this by boiling water, soaking the upper torso of the figure until the plastic gets softer and then carefully pulling the the arm out of the body at the shoulder joint. Sit these aside so they cool down. Remove head from one of the Slime Blower figures (be it Ray or Winston or both if you used both) while doing this as well. Remove the belts from all four by pulling the hose out of the leg socket and carefully sliding the belt down over the legs.
Remove the right arms & heads from the original 4 Ghostbusters using the same method. While the torso is still warm, pop the GB2 Slime Blower right arms into the GB1 bodies. Remove the belts from the original Ghostbuster figures the same way you did the GB2 (you mave have to clean up the socket holes a little more on these as the first releases uses a yellow coated wire and some of that coating may stick around).
Remove the heads from the Egon, Peter, and Ray or Winston (depending on which heads you took from the Slime Blower figures) GB2 figures. Warm up whatever Slime Blower head you removed before. Put these on your new khaki GB2 bodies you have created for each Buster. Slip the GB 2 belts carefully over their legs and plug the clear hose into the thigh socket. Done!
You could go a cheaper, easier route and just use the slimeblower body with new printed name tags... but since DST did unique sculpts for each Ghostbuster's body, I wanted to maintain that.
Hope it helps!
-James