User avatar
By Kodee-Wan
#4930260
I'm thinking about 3d printing a trap but I think I want to do a GB2 version to match my pack. Has anyone 3d printed this version? I have seen lots of GB1s floating around.
User avatar
By DarkSpectre
#4930285
There's minimal difference between the 2. If looking down on it, The knob on the right is now a silver barrel shaped and the side bars on the left are silver instead of red. So you could just print the trap and then customize it to GB2
    The journey from commonplace to Ecto-75.

    Whole car is great but the pack trolly...how?

    Proton Props???

    If anyone here is still pondering ordering from th[…]

    I haven't done the new update to the Spirits Unlea[…]

    I ended up grabbing one of the 84 wands just t[…]