Hey guys, I'm currently building a Ghost Trap, but before I put it all together I'm wondering if you all could help me find the measurements for the placement of the screw holes for the V-hook on the underside of the trap? I won't be getting the holster for another few months, but would like to pre-drill the holes so I don't have to take it apart again and do so in the future. I'll probably be buying the one available on the GBFans website, so if anyone is currently that model could you help a guy out? Thanks!I just measured mine... The first hole is 1/2" from the edge of the back wheel truck, and the holes are 1" apart. I don't know if that's "screen accurate" but putting the hook as far back as possible gave me the most room ahead of it to hook it onto the plate on the uniform.
Can I ask what kit you're building from? I built a Benofkent trap, and because of the height of the wheel trucks, I had to use a small square of acrylic as a standoff for the hook to allow it to reach the belt plate. If you're running into that same issue, I can dig back through emails and find exactly where I got that acrylic from, and the exact thickness.
I'm building Sean Charlesworth's trap, so not to sure what the differences are, but from looking at the photos I think the wheels recess a bit more into the bottom on his?
Well the thing is that the trailer makes me think[…]
Even if it their is a delay in getting my reissued[…]
This is something I'll always find a little hila[…]