|
THIS IS AN OLD VERSION OF THIS PAGE. TO VIEW THE NEWEST VERSION CLICK HERE
The grey 20-pin wire is used on the Ghost Trap Pedal. It can easily be found on many older computers. The correct one is grey with one red wire on the side. If you have a few old computers laying around, you should have plenty. The correct length is about 6 or 7 inches.
|
|
This page was last edited by AJ Quick on February 7, 2008, 4:48 pm
Link to this page: http://www.gbfans.com/equipment/ghost-trap/pedal/ribbon-cable/
Links Below This Category:
Ghost Trap Pedal - http://www.gbfans.com/equipment/ghost-trap/pedal/
D-Sub Housing - http://www.gbfans.com/equipment/ghost-trap/pedal/d-sub-housing/
Hammond Project Boxes - http://www.gbfans.com/equipment/ghost-trap/pedal/hammond-project-boxes/
ITT RM833212 3PDT Relay - http://www.gbfans.com/equipment/ghost-trap/pedal/itt-rm833212-3pdt-relay/
Octal Relay Socket - http://www.gbfans.com/equipment/ghost-trap/pedal/relay-socket/
|
|
 |
|