Return to Home Page -

[History] [Revise]Booster Plug

This small rod fits inside of the Booster Tube, slightly protruding past the edge (although at least one GB1 hero pack has it flush with the top of the tube). The bottom of the plug is about 2" deep on the hero packs.

For the semi-hero packs built for Ghostbusters II, the Booster Plug is very short with a shallow bottom. This is likely due to the prop-builders filling in the tube on the original buck in order to prevent undercuts during the casting process.

This page was last edited by Demon Vice Commander on November 30, 2011, 3:41 pm
Link to this page:

Links Below This Category:

Proton Pack Part Names -
Attenuator -
Bar Graph -
Barrel Trigger -
Booster Frame -
Booster Tube -
Bumper -
Crank Generator (Gearbox) -
Cyclotron -
Electrostatic Dissipation Assembly (EDA) -
Filler Tubes -
Front Cylinder -
Gun Track Disks -
Gun Ears -
Gun Knobs -
Gun Mount -
Gun Track -
Hydrogen Gas Actuator (HGA) -
Injectors -
Instrument Bar -
Ion Arm -
Ion Knob (Shock Mount/Knob) -
Motherboard -
N-Filter -
Power Cell -
Primary Power Distributor (PPD) -
Rear cylinder -
Ribbon Cable Clamp -
S-hook -
Slo-Blo -
Synchronous Generator (Spacer) - /
Trigger box -
Trigger tip -
V-hook -
Vents -

© 1998-2024 - Created by AJ Quick
"" is a registered Trademark of GBFans LLC.
"Ghostbusters" and "Ghost-Design" are registered Trademarks of Columbia Pictures Industries Inc.
Send Ghostbusters Fans an Email - [email protected] - Jurassic Jeep - 65 Million Years in the Making -